The raw material of the regenerated cryolite powder production line using electrolytic aluminum carbon slag treatment comes from the waste residue generated during the aluminum electrolysis process. The production cost is low, and the hydrogen fluoride gas generated during the waste residue treatment process can be repeatedly recycled to produce cryolite products after being absorbed by water or alkali. The cryolite products produced are mainly used as fluxes for aluminum electrolysis, so the cryolite produced by this method is called recycled cryolite.
Cryolite Powder Raymond Mill, welcome to leave a message or consult [email protected]
Grind the aluminum electrolysis waste residue through a Cryolite Raymond Roller Mill to below 75-250 microns. After removing the carbon and iron in the waste residue, add concentrated sulfuric acid and react for 30-1800 minutes at a temperature of 20-90°C. The hydrogen fluoride gas produced during the reaction is absorbed with water or alkali solution. After the reaction is completed, add 1-20 times the mass of waste residue water, stir for 2-20 minutes, filter, and add 10-30% mass fraction of sodium carbonate solution or solid sodium carbonate and 10-50% mass fraction of hydrogen fluoride to the filtrate. acid. Stir and react for 1-3 hours at 20-95 degrees to obtain cryolite slurry. After filtering, washing and drying, the cryolite product is obtained. Then it is processed by a cryolite grinding machine to obtain the finished cryolite powder.
1. Broken
The electrolytic slag is sent to the jaw crusher and broken into small pieces.
2. Grinding
The crushed small pieces are sent to the cryolite mill and ground into powder.
3. Stir
The powdery electrolytic slag is fed into the mixer and stirred evenly.
4. Flotation
The uniformly stirred electrolytic slag is sent to the flotation machine and undergoes three steps: rough selection, primary selection, and secondary selection.
5. Liquid-solid separation
The flotated material is pumped into a ceramic filter for liquid-solid separation. This is the "prototype" of artificial cryolite.
6. Drying
The separated solid material (cryolite) is sent to a three-pass dryer for further drying, and the result is artificial cryolite. The cryolite product is ground again by a cryolite mill to obtain the finished product of cryolite powder as a cosolvent in the aluminum plant.
Guilin Hongcheng is a manufacturer of cryolite Raymond mills. Our HC series Raymond mills are widely used in cryolite powder production lines. We have rich customer cases for electrolytic aluminum carbon slag processing and cryolite finished product grinding. experience. It can process 80-400 mesh powder, the fineness can be adjusted, and the output can be selected from 1-50t/h. It has complete models and rich categories. If you have cryolite mill purchase needs, please leave us a message to learn more about the equipment details.
